HYTEC E736 TURBO

1. Subfloor preparation

Proper groundwork is essential for effective crack bridging:

• Substrates must be firm, dry and free from dust, grease and contaminants
• Remove weak layers, coatings and residues using mechanical preparation methods
• Thoroughly vacuum all loose particles
• Dense or non-porous surfaces should be mechanically abraded and cleaned
• Apply a compatible primer where required depending on the system used

Substrates must meet site standards and be ready for bonding before installation.

2. Crack and joint preparation

• Cracks up to 0.3 mm can be treated without opening
• Cracks ≥0.3 mm should be mechanically opened and cleaned
• Remove all dust using industrial vacuum equipment
• Larger cracks (>1 mm) may require structural verification before repair
• Ensure joints are free from debris and loose material

Correct preparation ensures proper fleece integration and long-term performance.

3. Application

• Apply a thin, even layer of chosen system (repair mortar, epoxy or SMP/PU adhesive) at least 30 cm either side of the crack
• Place pre-cut fleece sheets (0.8 × 0.6 m) perpendicular to the crack direction
• Press firmly across the entire surface to ensure full contact
• Apply additional material over the fleece to completely encapsulate it
• Maintain overlaps of 5–10 cm where sheets meet
• Allow the system to set before proceeding with subsequent layers

Designed to reinforce cracks and accommodate movement across different substrates without resin injection.

4. Drying & curing

• Allow the base material (mortar, resin or adhesive) to cure before continuing

Typical next steps:

• Proceed with levelling compound or floor installation once set
• Refer to the corresponding system (mortar/resin/adhesive) for curing times

5. Underfloor heating

• Switch off heating systems 48 hours before, during, and for at least 48 hours after installation
• Gradually bring heating back up to operating temperature after curing

Common mistakes to avoid

• Not preparing cracks adequately before installation
• Incorrect orientation of fleece (must be perpendicular to crack)
• Insufficient overlap between sheets
• Incomplete embedment or exposed fleece
• Applying onto contaminated or dusty substrates
• Skipping primer where required
• Applying outside recommended temperature range (+15°C to +30°C)